 |
 |
|
 |
 |
[ ICD02 ] Microchip MPLAB ICD2 / ICD 2 Debugger / Programmer
++ Full Speed ++
With Adapter For PIC (Universal 40-PIN ZIF Socket Programming Module)
 1 |
This kit contains the MPLAB ICD2 module, a RJ12 cable, an USB cable and Adapter For PIC (Universal 40-PIN ZIF Socket Programming Module). |
|
The package includes
- One ++ Full Speed USB ++ Microchip ICD2/ICD 2 Debugger ~ Programmer
- One Adapter For PIC (Universal 40-PIN ZIF Socket Programming Module)
- One RJ12 Cable
- One USB Cable
- Manual on CD Rom
|
|
|
|
Summary :
| 1 |
An all-in-one debugger/programmer solution the MPLAB ICD 2
is a low cost, real-time debugger and programmer for selected PICmicro MCUs. Using Microchip Technology's proprietary In-Circuit Debug functions, programs can be downloaded, executed in real time and examined in detail using the debug functions of MPLAB. Watch variables and breakpoints can be set from symbolic labels in C or assembly source code, and single stepping can be done through C source line, assembly code level, or from a mixed C source and generated assembly level listing. MPLAB ICD 2 can also be used as a development programmer for supported PICmicro MCUs.
The secret behind In Circuit Debugging is the two dedicated hardware lines (microcontroller pins used only during debugging mode) that allow in circuit serial programming (ICSP) of the device and debugging capability through proprietary firmware. The ICD 2 debug features are built into the microcontroller and activated by programming the debug code into the target processor. There is some shared overhead expense that includes one stack level, some general purpose file registers and a small area of program memory when in the debug mode. |
| 1 |
Features :
- USB (Full Speed 2 M bits/s) & RS 232 interface to HOST PC
- Real time background debugging
- MPLAB IDE compatible (free copy included) /li>
- Built in over voltage/short circuit monitor
- Firmware upgradeable from PC
- Totally enclosed
- Supports low voltage to 2.0 volts. (2.0 to 6.0 range)
- Diagnostic LED’s (Power, Busy, Error)
- Reading/Writing memory space and EEDATA areas of target microcontroller
- Programs configuration bits
- Erase of program memory space with verification
- Peripheral freeze-on-halt stops timers at breakpoints
The MPLAB ICD 2 connects using USB or RS-232 between the design engineer's PC operating with MPLAB IDE and their product board (target) being developed. It acts as an intelligent interface/translator between the two, allowing the engineer to look into the active target board's microcontroller, viewing variables and registers at breakpoints with MPLAB watch windows. A breakpoint can be set to halt the program at a specific location. The program can be single-stepped or run at full speed. At breakpoints data and program memory can be read and modified. Additionally, the MPLAB ICD 2 can be used to program or reprogram the Flash-based microcontroller while installed on the board. |
|
|
|
|
|
You are buying directly from the manufacturer
